Track topics on Twitter Track topics that are important to you
Comparative study between custom-made polyether ether ketone and titanium mesh for augmentation of atrophic posterior mandible.
Designing and manufacturing
1. The CBCT images of the patient will be used to build a digital model using a 3D planning software (Mimics innovation suite). Based on this model, a machine will be used to mill a pressed and pre-sintered body of PEEK to the desired macroscopic shape.
2. The size of the machined sheet is enlarged in order to compensate for the sintering shrinkage performed at 1450 C.
3. After manufacturing, the sheet will be cleaned in an ultrasonic bath of 70% alcohol for 15 min, followed by a brief heating to 1200 C.
4. It will be again cleaned in an ultrasonic bath for 3x15 min using 90% alcohol.
5. Thereafter the sheet was placed in an autoclave and sterilized using a standard program.
6. The sheets will have a thickness of approximately 0.5 - 0.7 mm. b. Surgery
1. The intraoral area is initially cleaned with chlorhexidine 1 mg/ml.
2. Local anesthesia is administered.
3. Horizontal crestal incisions are made lingual of the mid-crest within the keratinized tissue. Vertical releasing incisions are placed on the buccal aspect of the surgical site in the usual manner to provide adequate access and to allow for eventual coronal repositioning.
4. Then, a full-thickness mucoperiosteal flap is reflected to completely expose the atrophic ridge.
5. The cortex of the mandibular crest is generously perforated to produce bleeding in multiple sites. The pilot holes for the fixation screws were also prepared at this time.
6. The barrier is inserted over the mandible and compressed into place, the fixation screws are inserted and no adaptation will be needed as the barrier is custom-made for the edentulous ridge.
7. The ceramic sheets is cleaned with 3% hydrogen peroxide prior to soft tissue closure.
8. After fixation of the sheets, the buccal flaps should be coronally repositioned.
9. Split-thickness periosteal releasing incisions are completed to aid in primary tension-free closure. The flap margins are then advanced over the barrier and approximated to evaluate for tension-free closure.
10. After a mean of 6 months of uneventful healing, the augmented sites are reopened. The ceramic barrier and fixation screws are identified and removed, followed by Dental implant.
Avoid traumatization of the surgical site. Patients must abstain from brushing at the surgical area. Instead, a disinfecting mouth rinse should be used (e.g. chlorhexidine 0.2%).
Instruct the patient not to touch or manipulate the surgical area. Ice packs for 10 minutes every 30 minutes for 24 hours. Do not use removable dentures during the expansion phase. Temporary fixed partial dentures must be adjusted to the expected tissue gain.
No consume of tobacco
Post-operative medications will be prescribed as follows:
Amoxicillin/clavulanic acid tablets 10mg/kg every 12 hours for 7 days, diclofenac potassium 50mg every 8 hours for 4 days and then as needed, metronidazole 5 mg/kg every 8 hours for 7 days and chlorhexidine gluconate 0.1% mouthwash 3 times daily for 14 days.
11b. Criteria for discontinuing or modifying intervention: No protocol for discontinuation of the procedure. 11c. Strategies to improve adherence to intervention: Face to face adherence reminder session will take place to stress on the post-operative instructions at the following time intervals.
Patients were recalled every other day to monitor soft tissue healing for the first week, one visit weekly for the first month then monthly for 6 months.
under local anasthesia,Ridge Augmention of posterior atrophic mandible by using mix of autogenous bone graft and bone substitutes is used under PEEK mesh
Faculty Of Dental and Oral Medicine-Cairo University
Published on BioPortfolio: 2019-07-17T10:04:59-0400
The use of implants has significantly increased prosthetic options for edentulous patient. However, implant placement in the Posterior mandibular region is often hampered significantly by ...
Mandibular ridge splitting with complete separation of the buccal cortical plate versus Khoury shell technique for horizontal augmentation of atrophic posterior mandible
Atrophic ridge augmentation utilizing guided bone regeneration (GBR) has become a major treatment option to provide optimal bone support for osseointegrated dental implants. GBR was initia...
aim Evaluation of the amount of bone gain following Ridge augmentation using tunneling technique in atrophic posterior mandibular ridges using anorganic bovine bone derived mineral mixed w...
The effect of adding Nanobone on horizontal bone gain in ridge splitting.
To evaluate whether 5-mm short dental implants could be an alternative to augmentation with anorganic bovine bone and placement of at least 10-mm long implants in posterior atrophic jaws.
To test whether or not alveolar ridge preservation reduces vertical changes in the posterior maxilla compared to spontaneous healing following tooth extraction.
Bone grafting has become an integral part of implant dentistry. To achieve a predictable long-term outcome for osseointegrated implants, a sufficient volume and quality of alveolar bone must be presen...
Posterior atrophic jaws rehabilitated with prostheses supported by 6-mm-long 4-mm-wide implants or by longer implants in augmented bone. Five-year post-loading results from a within-person randomised controlled trial.
To evaluate whether 6-mm-long by 4-mm-wide dental implants could be an alternative to implants at least 10-mm long placed in bone augmented with bone substitutes in posterior atrophic jaws.
Posterior atrophic jaws rehabilitated with prostheses supported by 5 × 5 mm implants with a nanostructured calcium-incorporated titanium surface or by longer implants in augmented bone. Five-year results from a randomised controlled trial.
To evaluate whether 5 × 5 mm dental implants with a novel nanostructured calcium-incorporated titanium surface could be an alternative to implants at least 10-mm long placed in bone augmented with bo...
Preprosthetic surgery involving rib, cartilage, or iliac crest bone grafts, usually autologous, or synthetic implants for rebuilding the alveolar ridge.
A masticatory muscle whose action is closing the jaws; its posterior portion retracts the mandible.
Malocclusion in which the mandible is posterior to the maxilla as reflected by the relationship of the first permanent molar (distoclusion).
GASTRITIS with atrophy of the GASTRIC MUCOSA, the GASTRIC PARIETAL CELLS, and the mucosal glands leading to ACHLORHYDRIA. Atrophic gastritis usually progresses from chronic gastritis.
The posterior process on the ramus of the mandible composed of two parts: a superior part, the articular portion, and an inferior part, the condylar neck.
Surgery is a technology consisting of a physical intervention on tissues. All forms of surgery are considered invasive procedures; so-called "noninvasive surgery" usually refers to an excision that does not penetrate the structure being exci...
Anesthesia is the loss of feeling or sensation in all or part of the body. It may result from damage to nerves or can be induced by an anesthetist (a medical professional) using anesthetics such as thiopental or propofol or sevoflurane during a surgical ...